Brief Introduction
FAT-50E-16E1 adopts 1U high standard 19″ rack. It is composed of 1+1 optical interfaces, 16 E1 interfaces, 4 electrical ETH interfaces or 3 electrical ETH interfaces and 1 SFP 100M optical ETH interface, 1 EOW interface, 1 ETH NMS interface, 1 RES232 NMS interface, 1 RS232 interface, 1 Alarm interface, 1 220VAC power supply and 1 -48VDC power supply.FAT-50E-16E1 Equipment supports RS232 and ETH management; it can manage the PDH equipment through the whole WAN network. It realizes remote update function, Alarms, performance monitor, and parameters setting are available through the ETH NMS interface.The equipment is featured by very compact, minimum cost and low power consumption. It is ideal for application areas such as remote transmission in point.
Features
- Networking ability, can build up PDH network through the WAN network;
- Support RS232 and ETH NMS management, and user can manage all the PDH equipment through WAN network;
- Support Remote update function;
- Alarms, performance monitor, and information about the local/remote equipment status are available;
- Optical interface: 150Mb/s, 60Km transmission without repeater, support 1+1 production;
- Providing 16E1 interfaces, local/remote loopback is supported;
- 4ETH interfaces, and user can select 4 electrical ETH interfaces or 3 electrical ETH interfaces and 1 100Base-FX SFP optical ETH interface by DIP switch, supports special VLAN, VLAN, broadcast protection, and enable or disable the ETH interface;
- Providing Engineering Order Wire (EOW), ETH NMS interface and RS232 interface (NMS) for equipment management;
- Provide 1 RS232 interface for user application;
- Both AC 220 and DC-48 are available;
- Single board design, 1U high, and 19 Inch wide.
- Optical interface
Speed: 150Mb/s ±50ppm
Output optical power: ≥-15dBm
Receiving sensitivity: ≤-35dBm
Optical wave length: 1310nm/1550nm
Optical interface connector: SC/FC - 2M interface
Bit rate: 2048Kbps ±50ppm
Code type: HDB3 code, conforming to G.703 standard
Input impedance: 75Ω(unbalanced interface), 120Ω(balanced interface) optional
Frame structure: Conforming to G.704, G.706
Compression law: Conforming to G.711
Level: ±2.37V ±10% - ETH interface (10/100M UTP)
Speed: 10/100Mbps, half/full duplex auto-negotiation
Standard: Compatible with IEEE 802.3, IEEE 802.1Q (VLAN)
Connector: RJ45 - ETH interface (100BASE/FX)
Speed: 10/100Mbps, half/full duplex
Standard: Compatible with IEEE 802.3, IEEE 802.1Q (VLAN)
Connector: RJ45 - Order Wire interface
Telephone set: standard 2 line telephone
Bandwidth : 64Kb/s
Coding: SFP/LC - Dimension and weight
Dimensions: 440mm(w)×270mm(d)×44mm(h)
Net weight: 4Kg - Power Supply
Input voltage: Standard value DC-48V and AC220V
Application
