Oil, gas and electricity

Alarm Monitoring of unmanned site

Nowadays, with the expansion of communication networks, launching unmanned or unmanned sites in different places such as highlands, in the suburbs, whether on land or at sea, to establish integrated
communication in various telecommunication platforms or radar sites is very common. Therefore, controlling the entry and exit of authorized persons, or monitoring warning signs such as sensors, as well as controlling remote communication equipment to reduce the cost of visiting and maintaining sites has become particularly important.
The FTI-B110 model device is used to monitor various environmental alarms, execute commands and control communication equipment through various RS232, RS485 and CAN ports at the mentioned sites. In addition to displaying points and sites on the map, this device also has the ability to send SMS to pre-specified numbers, this system can communicate with CCTV cameras and smart grids It also has face recognition, which can be used to control the opening and closing of the site’s doors, setting up control equipment in case of defined problems, and programming other alarms intelligently by the system. (Optional)
This system can transmit commands and alarms on the SIM card or pre-specified numbers,also it can receive some commands from the specified numbers on the sever system .
In this device, in addition to the possibility of connecting the system through the Ethernet port, it can transfer the relevant data on the SIM card or Lora modules.
In addition to the above, this system can intelligently control the site temperature, disconnect and connect the heating and cooling equipment of the site and control the desired temperature to increase the life of the equipment. This system can be connected to the input power of the site to switch the input power to UPS systems as well as diesel generators.

The input and output ports of this device include the following:

8 relay ports to receive or send disconnect and connect commands
8 digital input ports to receive alarms of various sensors such as smoke sensor, door opening and closing, fire sensor and …..
4 ports with the possibility of controlling and receiving information, including: RS232 serial, humidity sensor, temperature sensor and wind sensor, etc.
16 digital outputs to control equipment or change the channel of different types of radio repeaters
1 port of CAN or RS485
3 AC power outages
3 platforms for sending information LORA, GSM, ETH

Several communication platforms are used to communicate with the central server in this device , and even it can back up from communication platforms , which can be provided as an option according to the needs.
System communication platforms include:

Ethernet or network
Optical fiber
phone line
GSM SIM card
LORA LORA WAN

In this system, it is possible to send alarms and issue control commands simultaneously through the numbers defined in the server , so that the mobile phone numbers defined in the server can be operators (only monitoring alarms) or admin (monitoring).
All system commands and logs are stored in the server.

This system can be connected to the following types of sensors:

– Smoke sensor

– temperature sensor, thermometer

– Outdoor and indoor motion sensor

– Sensor open and close the door

– Wind sensor (direction and speed)

– humidity sensor

This system has the ability to communicate with all types of fire alarm and extinguishing equipment

-Control of cooling systems such as cooling and heating systems

– Control of disconnection and connection of input power

– Control and start of diesel generator

-Change channels and control commands for all types of wireless and remote repeaters

– Issuing commands to starting and ending the alarm

– Opening and closing the entrance and exit doors

IP based Systems

Transmission Systems

Monitoring and Command System

Radio Equipment

Airports